d align=right>

Stadium Penco Products, Inc. 99 Brower Ave. PO Box 378 Oaks, PA 19456-0378
1-800-562-1000 610-666-0500 Fax 610-666-7561 www.pencoproducts.com
Stadium Locker

Assembly Instructions
Assembly of Stadium Locker
All bolts are to be inserted on outside of locker while all
nuts are to be placed on the inside of the locker.
Part No.
Bottom
Back
Panel
Hooks
Top
Rod Holder
Rod
Locker
Frame
Side Panel
Side Panel
View of Locker
with Back on Floor or Saw Horses

for Knocked Down Version
Shelf
Optional
Security
Box and
Shelf
Optional
Footlocker
page 1 of 2
1. Place back panel on a pair of saw horses.
2. Bolt hooks to back panel.
3. Bolt one side panel to back panel.
4. Bolt bottom to side and back panel.
5. Bolt second side panel to bottom and back panel.
6. Loosely bolt shelf and rod holders to side panels and
insert rod into rod holder holes.
7. Bolt top to side panels and back panel.
8. Tighten bolts that anchor shelf and rod holders.
9. Place locker frame over outside edge of side panels, bottom and top and bolt together.
10.Stand locker upright and install on a level surface.
11. Line up number plate with holes at front of shelf and rivet into place.
We recommend that all lockers be anchored to the floor and / or wall.
See next page for instructions on assembling Security Box and Footlocker. Stadium Locker Assembly Instructions
Assembly of Security Box
1. Loosely Bolt box side to shelf and top.
2. Open door to door frame assembly.
3. Bolt the door frame assembly to the
side panel, top and box side.
4. Tighten all loose bolts.
5. Close door and check aligment.
Assembly of Foot Locker
1. When installing locker frame
(see page 1, step 9) leave bolts off bottom section.
2. Loosely bolt side seat supports (with support slot towards front of locker) to side panels.
3. Slide front footlocker panel down until downward bend on the top of the footlocker panel fits into side seat
supports slot. Loosely bolt front footlocker to locker frame.
4. Loosely bolt seat with hinge to side seat supports.
5. Align seat and hinge to front footlocker panel.
6. Tighten all loose bolts.
7. Insert rubber bumpers in holes at top of footlocker front panel and where open seat meets back panel.
Penco Products, Inc. 99 Brower Ave. PO Box 378 Oaks, PA 19456-0378
1-800-562-1000 610-666-0500 Fax 610-666-7561 www.pencoproducts.com
for Optional Security Box & Footlocker
Rubber
Bumpers
Rubber
Bumpers
Knocked Down
Version
Box Side
Door
Frame
Assembly
Seat
with
Hinge
Side
Seat
Support
Front
Footlocker
Panel
instruct\stadium\stadium3.p65 2/00
page 2 of 2
Optional Security
Box and Shelf
Optional
Footlocker
Close up of
Side Seat
Support Slot