=0 cellpadding=7 cellspacing=0 width=100% bgcolor=ccccff> « back to results for ""
Below is a cache of http://www.persistor.com/doc/cf2/cf2gsg.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.
CF2 Gettting Started Guide PERSISTOR
®
CF2
Getting Started Guide



























Copyright © 2002-2005 Persistor Instruments Inc. All Rights Reserved.
Revision 1.9 March 2005


Standard Terms and Conditions of Use

Life Support and Safety Equipment: PERSISTOR INSTRUMENTS INC (PII) PRODUCTS ARE NOT
DESIGNED, TESTED, OR INTENDED FOR USE IN EQUIPMENT THAT MAY, BY FAILURE, MISUSE OR
PROPER USE, CAUSE DEATH, INJURY, OR LOSS OF PROPERTY. Designers of such equipment assume
full responsibility for protection against, and the liability for damages arising from, the failure of PII
products.
Specifications: Product specifications are subject to change without notice. PII reserves the right to
improve or change the specifications at any time.
Limited Warranty: PII warrants hardware, which is manufactured or certified by PII, to perform
within the published specifications at the time of purchase, for a period of one year from the time of
purchase. The buyer assumes the responsibility for confirming products purchased from PII perform
within the published specifications when placed in the buyer's application. This warranty does not
cover damage or depreciation due to operating conditions or environments, or damage due to abuse,
accident, or customer modification. Damage due to static dissipation or corrosive environments are
specifically excluded. PII warrants software, which is produced by PII, to perform within the
published specifications at the time of purchase, for a period of 90 days from the time of purchase.
Products sold by PII, but which are not manufactured or certified by PII, are not warranted by PII.
Remedy for Warranty Failures: PII will, as PII chooses, repair or replace a defective hardware or
software product, under the following conditions: the item is returned within the warranty period, a
reproducible symptom of the defect can be described, the defective item is not found to be damaged
by misuse or abuse.
Limitation of Warranty: TO THE FULLEST EXTENT OF LAW, PII MAKES NO OTHER WARRANTY,
EXPRESSED OR IMPLIED; INCLUDING ANY PRESUMED, EXPRESSED OR IMPLIED WARRANTY AS TO
THE SUITABILITY OF THE PRODUCT FOR ANY PARTICULAR PURPOSE. TO THE FULLEST EXTENT OF
LAW, PII SPECIFICALLY EXCLUDES ANY IMPLIED WARRANTY OF TITLE OR NON-INFRINGEMENT.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY HAVE OTHER LEGAL RIGHTS,
WHICH VARY FROM STATE TO STATE.
Limitation of Liability: TO THE MAXIMUM EXTENT ALLOWED BY LAW, IN NO EVENT SHALL PII OR
ITS SUPPLIERS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING WITHOUT LIMITATION INJURY OR DEATH, LOST OR INADEQUATE DATA OR
INFORMATION, LOST REVENUES OR PROFITS, LOST USE OR BUSINESS INTERRUPTION,
REPLACEMENT OR RENTAL COSTS ARRISING FROM THE FAILURE OF, OR INABILITY TO USE PII
PRODUCTS. IN NO EVENT SHALL PII'S LIABILITY FOR ANY DAMAGES EXCEED THE PURCHASE PRICE
OF THE PRODUCT.

Trademark Notice
Persistor®, PicoDOS®, and MotoCross® are registered trademarks of Persistor Instruments Inc.
RecipeCard and SandwichCard are unregistered trademarks of Persistor Instruments Inc. All
other names, brands, and trademarks are the property of their respective owners.
P E R S I S T O R
I n s t r u m e n t s I n c
.

2
CF2 Getting Started Guide


Table of Contents
Standard Terms and Conditions of Use ............................................................................ 2

Trademark Notice........................................................................................................... 2

Table of Contents ............................................................................................................ 3

General Information........................................................................................................ 4

Introduction .................................................................................................................. 4

Whats in the Kit? ........................................................................................................... 4

Additional Equipment Required......................................................................................... 4

Warnings and Precautions............................................................................................... 5

Software Installation....................................................................................................... 6

Overview ...................................................................................................................... 6

A Note to CodeWarrior Pro 6 Users................................................................................. 6

Install CodeWarrior ...................................................................................................... 7

Install PicoDEV with MotoCross
®
....................................................................................... 8

Setup the Source Trees ................................................................................................... 8

Installed Files ................................................................................................................ 9

Hookup and Sign On ...................................................................................................... 10

Introduction to RecipeCards and SandwichCards.......................................................... 10

What Are You Using? .................................................................................................... 10

Hook Up...................................................................................................................... 11

CF2 C Programming Tutorial.......................................................................................... 12

Your First Project.......................................................................................................... 13

Renaming the Target .................................................................................................... 15

Compiling.................................................................................................................... 16

What Happened?.......................................................................................................... 16

Beyond Standard C Libraries .......................................................................................... 17

Stationery ................................................................................................................... 17

Subsystems................................................................................................................. 18

Specifications ................................................................................................................ 21

Absolute Maximum Ratings ............................................................................................ 21

Physical Specifications .................................................................................................. 21

Electrical Characteristics................................................................................................ 21

Block Diagram and Signal Connections ............................................................................ 22

Pin Descriptions ........................................................................................................... 23

Power Connections........................................................................................................ 25

UART Connections ........................................................................................................ 26

QSPI Connections......................................................................................................... 27

TPU Time Processor Unit............................................................................................. 28

CF2 Dimensions ........................................................................................................... 29

PCB Pad Placement....................................................................................................... 29

Common CF2 Problems and their Solutions ................................................................... 30

P E R S I S T O R
I n s t r u m e n t s I n c
.

3
CF2 Getting Started Guide


General Information

Introduction
Thank you for your recent purchase of a Persistor CF2. We welcome your comments and suggestions
for improving our documentation.
This getting started guide describes how to setup and install the various com