ding=10 cellspacing=0 width=100%>Yahoo! is not affiliated with the authors of this page or responsible for its content.




OPERATION & INSTALLATION TIPS
1. Connect both pin sets of the socket before connecting RED & YELLOW wires.
2. Ground case in accordance with the National Electric Code.
3. With Linear lamps, use a starting aid.
4. Ballast case temperature can not exceed 70°C.
5. Remote mounting distance varies with lamp type. Contact customer service.
6. Ballast can not be used with dimmer switch but can be used with Occupancy Sensor.
(Note: Sensor will shorten lamp life.)
7. Cap and insulate any unused red power wire.
8. When connecting two red power wires, they must be joined
to make one wire before attaching to the socket.
9. BLS (Back Leads with Studs) Dimensions:
Stud Length: 5/8, Stud Size: 8/32, Center to Center: 2
10. Running lamps in series will reduce the turn-on cycles of both lamps.
(Configuration diagrams 4, 5, 6)
29