> Below is a cache of http://www.cwservice.com/FirewireNoticeGenericVersion6212006.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.



Important Sony i.LINK Installation Information

Care must be taken when connecting the Sony i.LINK ( IEEE 1394 / FIREWIRE) into your PC /
MAC Computer or other Device. The Sony i.LINK connector design is dictated by the IEEE 1394
industry standard and the socket and cable are constructed with a keyed guide to assist with
proper installation. It is necessary to visually confirm that the plugs and sockets are lined up
correctly for proper installation and to prevent damage to the internal circuitry of the units.

Even though the plug and socket will only fit completely together properly in one
direction, there is still power present if either device is powered on.

If there is an attempt to insert the plug INCORRECTLY (wrong polarity) the PC / MAC Computer
or other Device can supply power to the signal pin of the i.LINK. This directly connects to the
i.LINK IC and can damage the circuit.

In order to prevent accidental damage, the following steps must be followed when
connecting DVCAM equipment to a PC / MAC Computer or other Devices via the i.LINK
Port:

1. Power down the Computer / Device and DVCAM
2. Connect the i.LINK cable to the Computer / Device by visually confirming
proper fit and polarity.
3. Connect the i.LINK cable to the DVCAM by visually confirming proper fit and
polarity.
4. Turn on the power to the Computer / Device and then the DVCAM.

Please review these instructions carefully. Damage to the DVCAM i.LINK
components caused by improper installation is not covered by Sonys
warranty.