and strength.The thermocouple tip is pre tinned to ease soldering to the PCB.We recommend
the use of an activated flux and high temperature solder to attach this thermocouple to the
PCB assembly.
Thermocouple Material:
Type K Special Limits of Accuracy
Accuracy:
±1.1ºC or 0.4% of the reading (whichever is greater)
Length:
800mm
*
Conductor Diameter:
0.2mm
Temperature:
265ºC maximum
*
Other lengths available on request
www.datapaq.com
PA1683
FINE WIRE
This thermocouple has been developed specifically for use with BGA and ultra fine pitch surface
mount components.The type K thermocouple conductors are 0.1mm in diameter, each insulated
with PTFE. The two conductors are then over-wrapped with a single outer PTFE sheath to
prevent tangling in use. The recommended attachment method is activated flux and high
temperature solder. For BGA, the accepted practice is to drill through the PCB and insert the
tip until it touches a ball and then bond the thermocouple wire in place.
Thermocouple Material:
Type K to British Standard Class 1
Accuracy:
±1.5ºC or 0.4% of the reading (whichever is greater)
Length:
500mm
Conductor Diameter:
0.1mm
Temperature:
265ºC maximum
PA1571
ULTRA FINE DIAMETER MINERAL INSULATED
The PA1571 is intended for use in high temperature applications. It is a Type K Mineral Insulated
thermocouple with an Inconel outer sheath. The overall diameter is 0.5mm. It can operate to
1,000ºC. Attachment method will depend on the application but can include ceramic cement
or mechanical fixtures.
Thermocouple Material:
Type K to British Standard Class 1
Accuracy:
±1.5ºC or 0.4% of the reading (whichever is greater)
Length:
600mm
Conductor Diameter:
NA (outer sheath is 0.5mm)
Temperature:
1,000ºC maximum
North and South America
DATAPAQ Inc.
187 Ballardvale Street
Wilmington, MA 01887, USA
Tel:
+1 978 988 9000
Fax:
+1 978 988 0666
e-mail:
sales@datapaq.com
Web:
www.datapaq.com
Germany
DATAPAQ GmbH
Valdorfer Straße 100
D-32602 Vlotho, Deutschland
Telefon:
+49 5733 9107 0
Fax:
+49 5733 9107 27
e-mail:
sales@datapaq.de
Web:
www.datapaq.de
PA0215
FIBRE INSULATED PROBE
Exposed junction type K thermocouple constructed from 0.2mm wire with glass fibre insulation.
This probe is designed for continuous use up to 500°C and is therefore ideally suited to high
temperature soldering applications. For best results we recommend that the probe is attached
using an activated flux and high temperature solder.
Thermocouple Material:
Type K Special Limits of Accuracy
Accuracy:
±1.1°C or 0.4% of the reading (whichever is greater)
Length:
800mm
Conductor Diameter:
0.2mm
Temperature:
500ºC maximum
Europe and Asia
DATAPAQ Limited,
Deanland House, 160 Cowley Road,
Cambridge CB4 0GU, UK
Tel:
+44 (0)1223 423 141
Fax:
+44 (0)1223 423 306
e-mail:
sales@datapaq.co.uk
Web:
www.datapaq.com