embly using the rubber boot that is provided. Do not over
tighten the rubber boot hex nut. See Figure 1.
Note: The switch bushing should protrude approximately 0.15 (3.8mm)
through the front cover.
WIRING
1.
Remove the jumper assembly that is installed on the FWD and
STOP terminals of the PC board. Using pliers, gently rock the female
terminals back and forth horizontally while pulling them upward.
See Figure 2.
2.
Install the white/yellow wire from the Forward-
Stop-Reverse Switch assembly to the FWD
terminal of the PC board. See Figure 3.
3.
Install the white/green wire from the Forward-
Stop-Reverse Switch assembly to the STOP
terminal of the PC board. See Figure 3.
4.
Install the white/red wire from the Forward-
Stop-Reverse Switch assembly to the REV
terminal of the KBAC PC board. See Figure 3.
5.
Use the wire ties that are provided to secure
switch wires.
INSTALLATION INSTRUCTIONS
FORWARD-STOP-REVERSE SWITCH
Part No. ID5FSR-1
for Model ID5601-WO, ID5601-BO, ID5602-WO, and ID5602-BO
!
Baldor Electric Company
P.O. Box 2400, Ft. Smith, AR 72902-2400
(479) 646-4711 Fax (479) 648-5792
(A40128) Rev. B 6/2003
RUBBER BOOT
FRONT COVER
SWITCH BUSHING
HEX NUT
NYLON SPACER
SWITCH BODY
FIGURE 1 MOUNTING THE SWITCH
STOP
FWD
REV
ID5601 PC BOARD
ID5602 PC BOARD
FORWARD-STOP-REVERSE
WHITE/YELLOW
WHITE/GREEN
WHITE/RED
WHITE/RED
WHITE/GREEN
WHITE/YELLOW
SWITCH
FORWARD-STOP-REVERSE
SWITCH
FWD
STOP
REV
FIGURE 3 CONNECTION DIAGRAM
SAFETY WARNING! Please read carefully before proceeding.
This product should be installed and serviced by a qualified technician, electrician, or electrical maintenance person familiar with its operation and the
hazards involved. Proper installation, which includes wiring, mounting in proper enclosure, fusing or other overcurrent protection, and grounding can
reduce the chance of electrical shocks, fires, or explosion in this product or products used with this product, such as electric motors, switches, coils,
solenoids, and/or relays. Eye protection must be worn and insulated adjustment tools must be used when working with control under power. This
product is constructed of materials (plastics, metals, carbon, silicon, etc.) which may be a potential hazard. Proper shielding, grounding and filtering
of this product can reduce the emission of radio frequency interference (RFI) which may adversely affect sensitive electronic equipment. If further infor-
mation is required on this product, contact the Sales Department.
This control contains electronic Start/Stop circuits that can be used to start and stop the control. However, these circuits are never to be used as
safety disconnects since they are not fail-safe. Use only the AC line for this purpose.
Be sure to follow all instructions carefully. Fire and/or electrocution can result due to improper use of this product.
It is the responsibility of the equipment manufacturer and individual installer to supply this Safety Warning to the ultimate end user of this product.
!
REMOVED
TO BE REMOVED
JUMPER
TERMINAL
INSTALLED
TERMINAL
ID5602 PC BOARD
REV
STOP
FWD
FWD
REV STOP
ID5601 PC BOARD
FIGURE 2 JUMPER ASSEMBLY
MN781-S3