B
LEG MOUNTED PROCEDURE
The laundry tub may be leg or wall mounted. Models
with an F suffix (SF-1F for example), are leg mounted
tubs, and are shipped with four leg assemblies. Leg
mounting is the same for single or double tubs.
To mount legs on tub, turn unit upside down and lay
on protected surface.
DETAIL B
Slip noched end of leg into corner of tub as shown
in DETAIL A.
Drive the leg home by striking with a wood block and
hammer. Apply one leveling device on each leg as
shown in DETAIL B. NOTE: Certain leg assemblies
have a Tinnerman Clip on the leveling device, rather
than two nuts.
Adjust all four legs after standing tub upright.
Steel Leg
Leveling Device
Anchors
(Furnished by others)
WALL MOUNTED PROCEDURE
Studding
Blocking
Lag
Screws
Bracket
Laundry tubs with an W suffix in the model number are
wall mounted tubs. Instead of legs, these tubs are shipped
with filler panels that must be installed. Drill out plastic filler
panel hole on the back of the tub skirt and Insert the tab (A)
into the slot under the tub rim. Push the anchoring barb (B)
into the hole in the tub skirt. Repeat for opposite panel.
Each of the filler panels are marked L or R and should
be installed accordingly.
When mounting tub to a stud wall, install wood blocking to
bridge the studs. For double tubs, fasten the mounting
brackets to the wall 33-1/8 up from floor with 1/4 lag screws.
Make sure lag screws drive into studs or blocking.
Note:
Single tub units use a single hanger. Fasten wall mounting
hanger to the wall 33-1/8 up from the floor with three 1/4 lag
screws. Two screws be placed in the outermost holes
of the bracket to properly attach the tub to the wall.
Lift and place sink over wall mounting bracket(s). Make sure
tub is seated securely on the lip of the mounting bracket(s).
See DETAIL C.
SINGLE TUB
MOUNTING BRACKET
DETAIL C
33-1/8
A
B
must
DETAIL A
Leg
Wall
Floor
R R
Packing List : Model SF-1W LTD II L1
Description
Qty.
1
Wall hanger bracket
Side filler panels, (1) L (1) R
1/4 lead screw anchors
Fasten wall mounting bracket
to concrete or cement block wall
construction by following the
same procedure for wood stud
walls discussed earlier.
Drill holes with a masonry bit
and use lead alloy screw
anchors with 1/4 lag screws
and flat washers.
A3 Faucet Adapter Kit
For top supply connection
faucets. (Optional)
A15 Overflow
Tube Kit
(Optional)
Apply teflon tape to drain
boss threads before
installation.
DETAIL OF FAUCET, SUPPLY LINES
WASTE LINES, AND TRIM ASSEMBLIES
1
2
Carton Includes:
1/4 lag bolts
5/16 flat washers
1
2
1
Stopper
Tail Piece
Illustrated installation manual
Packing List : Models SF-1F P-1 FL-7 FL-1 FLTD II
Description
Qty.
1
Molded laundry tub
Painted steel legs
Tinnerman clip
Carrige bolt
1/4 - 20 Hex nut
Stopper
4
4
4
Tail Piece
Illustrated installation manual
4
1
Packing List : TUFF TUB TO GO
Description
Qty.
1
Painted steel legs
Tinnerman clip
Carrige bolt
1/4 - 20 Hex nut
Stopper
4
4
4
1
Screw bag (for legs)
1
1
Illustrated installation manual
4
1
A-1 Faucet
P-Trap
Water Supply Lines
2
1
Packing tray (RMS999)
1
PRINTED IN USA Form No. 02P-1 Rev. 1/02.
1or 2
Molded laundry tub
Molded laundry tub
OPTIONAL EQUIPMENT
A-1 Faucet
Water Supply
Laundry Tub
Tail Piece Washer
P-Trap
1
2
3
4
5
TUFF TUB TO GO
A l l h a r d w a r e
n e e d e d f o r t h e
complete laundry
t u b i n s t a l l a t i o n .
3or 4
3or 4
3or 4
1or 2
1or 2
Installer must
provide teflon
tape.
Rough-in water
s u p p l i e s a n d
waste line must
be provided at
the installation
area.
1
A6 Laundry Tub
Cover. (Optional)
TAIL PIECE / STOPPER
ASSEMBLY
Typical Tail Piece / Stopper
Assembly
Installation is the same for double
or single basin laundry tubs.
Apply teflon tape to
threads before supply
connection.
1
Stopper
2
3
4
5
Washer
1or 2
Washer
1or 2
Washer
1or 2
3
1 Laundry Tub
2 Tail Piece Washer
3 Tail Piece
IMPORTANT NOTICE: The Gaskets / Washers supplied with the drain assembly should provide adequate water
seal. If additional protection is desired, use ONLY Teflon Tape. Use of Plumbers Putty may adversely affect the
structural integrity of the Drain Assembly and will void the warranty.
R
CR/PL 1235 Hartrey Ave. Evanston, IL. 60202