reed switch wires on the terminal strip. There is
no wrong way to connect these wires. Connect the two
heavy gauge wires from the ribbon cable to the motor
wires on the terminal strip. To tell if you connected your
motor wires correctly, press the east button on your
remote control: if your dish moves west, reverse the wires.
The bare braided wire does not connect to anything. If you
have any questions, call our Skyvision Technical
Department for assistance.
Mounting Instructions
Use washers (spacers) on the rear mounting plate and on the front mount arm to set your dish
mover at a 90° angle to the back of the dish. Washers can be put on the
top or bottom of the dish mover mounting bolts. In this example, the front
mount of the dish mover is on top of the mount arm, and the rear mount is
below the mounting plate. This will vary between dish movers and
brands of dishes. For example, on some dishes, the rear
and front mount of the dish mover will be below the
rear plate and front arm, or above at both ends.
TECHNICAL SUPPORT
800-500-9279
1010 North Frontier Drive Fergus Falls, MN 56537-1023
Form 600-46-1001
FYI
When you replace your
dish mover, you must
Master Clear your
receiver and reprogram in
all your satellites.
Installing Your Dish Mover
A
ll dish movers must be mounted at a 90° angle to the back side of the
satellite dish. If it is NOT mounted this way, unnecessary loads will be put on your dish
mover, causing undo stress on your dish mover.
View facing dish
with dish pointed
straight south.
YOUR DISH MOVER COMES COMPLETELY RETRACTED, OR
CLOSED. WHEN INSTALLING, YOU MUST POINT YOUR DISH
BELOW THE LOWEST SATELLITE TO ENSURE FULL RANGE
OF MOTION.
Dish movers
are also called
actuators or
jack arms.
Sensor Wires
Motor Wires
(heavy gauge)
Sensor Wires
Motor Wires
(heavy gauge)
Lower Limit
Switch
90°
Mount Arm
Mounting Plate
Saddle Clamp
Mounting
Bolt
Washers (spacers)
Sensor Wires
Motor Wires
(heavy gauge)
Sensor Wires
Motor Wires
(heavy gauge)
Lower Limit
Switch
90°
Mount Arm
Mounting Plate
Saddle Clamp
Mounting
Bolt
Washers (spacers)
Connections for Skyvision
SP, Skyvision UP & AP.
Reed Sensor for
Skyvision GP.
www.skyvision.com