in 50Hz, 60Hz or 400Hz for land,
marine or military applications, worldwide.
qTRUE SINE WAVE
q125 WATTS TO 1100 WATTS
q12VDC TO 108VDC INPUT
qRACK MOUNT OPTIONAL
qREMOTE SWITCHING
q21.5 YEARS MTBF
TECH
XP SERIES
XP SERIES POWER INVERTERS
XP 125
XP 250
XP 600
XP 1100
All specifications are subject to change without notice.
931-X**B*-*0D
Page 1 XP SERIES
PART NUMBERING
SYSTEM
Step 1:
Model number always starts
with XP.
Step 2:
To designate wattage enter the single character code
1 for 125, 2 for 250, 6 for 600, K for 1100
Step 3:
To designate output voltage enter the single character
code from the Vac chart

Step 4:
To designate input voltage enter the single character code from the Vdc chart
Step 5:
Output frequency is designated by using the first number of the frequency
5 for 50Hz, 6 for 60Hz and 4 for 400 Hz
Step 6:
This designates revision level (For EXELTECH use only).
Step 7:
To designate option, enter the code from the option chart below. If no option is required please leave it blank.
XP __ - __ - __ - __ - 1 - __ __
Vdc INPUT VOLTAGE CHART
DC Volts 12
24
32
48
66
108
Designation
1
2
B
4
E
I
Vac OUTPUT VOLTAGE CHART
AC Volts 100 120 230*
Designation
0
1
3
Code
Option
Conformal coating
Low idle current drain
Circuit board with heat sink only
07
02*
04**
OPTION CHART
EXELTECH XP SERIES
MODEL NUMBER
EXAMPLE:
XP600 with
117Vac output, 12Vdc input,
60Hz with the conformal
coating option would require
the following model number:
XP6-1-1-6-1-07
* available thru a distributor only(only on XP1100W)
**available for OEMs only
***available on XP600 and XP1100 only
7317 Jack Newell Blvd North
Fort Worth, Texas 76118-7100
817.595.4969 voice, 817.595.1290 fax
800.886.4683 toll free
e-mail address info@exeltech.com
e-mail address sales@exeltech.com
website www.exeltech.com
TECH
50MS transfer relay
20***
All specifications are subject to change without notice.
931-X**B*-*0D
Page 2
*Not available in 125watt models XP SERIES
OUTPUT POWER
CONTINUOUS
POWER
SURGE
POWER
NO LOAD
POWER
OUTPUT
VOLTAGE
OUTPUT
CURRENT
WEIGHT
LBS.
1100W
117
5.1
6.5
MODEL
VOLTAGE
MINIMUM
(TYPICAL)
SYSTEM
(TYPICAL)
MAXIMUM
(TYPICAL)
TYPICAL
EFFICIENCY
@ FULL
POWER
PEAK
EFFICIENCY
@ 1/3
POWER
12V
24V
32V
48V
66V
108V
10.4/10.6*
13.8V
16.5V
85%
87%
19/21V*
27.6V
33V
87%
89%
26.5/28V*
36.8V
44V
88%
90%
41.5/42.5V
55.2V
62V
87%
89%
57.5/58.5V*
75.9V
91V
88%
90%
94/95V*
125V
149V
87%
90%
INPUT POWER
*Indicates typical cut-off voltage/warning buzzer voltage
CONDITIONS
WAVEFORM
VOLTAGE OUTPUT
LINE REGULATION
LOAD REGULATION
DISTORTION
FREQUENCY
MINIMUM
-
-5%
-
-
-
-0.1%
TYPICAL
SINUSOIDAL
NOMINAL
0.1%
0.5%
1.5%
NOMINAL
MAXIMUM
-
+5%
0.5%
1%
2%
+0.1%
GENERAL
Case size (WxHxD)

125W case size= 4.93 x 2.00 x 6.80
(2 lbs)
250W case size= 5.23 x 2.77 x 10.38
(5 lbs)
600W case size= 7.70" x 3.60" x 11.77"
(6.5 lbs)
1100W case size= 7.70 x 3.60 x 14.77
(10 lbs)
MECHANICAL
ENVIRONMENTAL
Temperature: -25 to 30 C full power
derated above 30 C
Humidity: 5 to 95% non condensing
Altitude: -200 to 10k feet full power,
derated above 10k
Audible Noise: Less than 45dbA
Cooling: 600W/1100W Thermo-
statically controlled
forced air. 125W/250W
convection cooled.
Finish: Painted aluminum
Warranty: Full year parts labor
*Over Voltage: Shut off at maximum input
voltage, per input conditions.
Automatic reset upon fault
correction.
*Under Voltage: Shut off at minimum input
voltage, per input conditions
*Thermal: 105 C internal temperature.
Warning buzz 5 C before
shut off
Output Short: Unit shuts off (manual reset)
*Automatically reset
PROTECTION
CIRCUITRY
POWER INVERTER
SPECIFICATIONS
1100W
230
2.7
6.5
1100W**
1100W**
1100W**
600W**
250W**
250W**
250W**
125W
125W
600W**
600W**
8W
9W
6.5
1100W
8W
100
6.0
2200W
2200W
2200W
20W*
20W*
20W*
100
117
230
10
10
10
9.5
11.0
4.8
150W
150W
5W
5W
100
117
2
2
1.1
1.2
300W
300W
300W
6W
6W
7W
100
117
230
2.5
2.1
1.1
5
5
5
*10W with X2 option
**remote switchable
XP Options:
- conformal coating (07 option)
- low idle current drain (02 option)*
- circuit board with heat sink only
(04 option) many other options
available for OEM applications,
consult factory.
OPTIONS
*1100 watt only
1
1
+/- 3%
1
All specifications are subject to change without notice.
931-X**B*-*0D
Page 3
See www.exeltech.com for more data regarding XP Series inverters.
7317 Jack Newell Blvd North
Fort Worth, Texas 76118-7100
817.595.4969 voice, 817.595.1290 fax
800.886.4683 toll free
e-mail address info@exeltech.com
e-mail address sales@exeltech.com
website www.exeltech.com
TECH