cable to the speedometer.
Ensure the proper engagement of cable with the speedometer. This speedometer has a main
odometer and a trip odometer each of which indicates the distance in miles. The trip
odometer can be reset to zero miles by rotating the knob in the clockwise direction.

























Caution: This knob should not be rotated in the counterclockwise direction.

Connect the lamp terminals to the dash illumination switch.

Warning:
The speedometer is fitted with three 12-volt lamps at factory. If the Electrical
system of the vehicle is 24-volt, replace the 12-volt lamps with 24-volt lamps
(provided in kit).

To replace the lamps, rotate the lamp holders in counterclockwise direction (using pliers or
by hand) and remove them. The lamp can then be removed from the holder. Insert the
appropriate voltage lamp in the socket. The lamp holder can be fitted in the speedometer in
the reverse order of removal.
Main odometer
Trip odometer and trip reset Knob
+
and
-
Connection terminals
for speedometer illumination.
Rear view of the speedometer, showing the three T5
lamp holders and two connection terminals.
T5 Lamp
Holders

Form No. IS041 - (10/24/02 Rev. A) Page 2 of 2