th=10 nowrap> « back to results for ""
Below is a cache of http://www.bswusa.com/assets/pdf/BSW_2008C_193-207_interface-equipment.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.
INTERFACE EQUIPMENT DISTRIBUTION AMPLIFIERS
193
order/info: 1·800·426·8434 www.bswusa.com
Broadcast
Tools 2X6
Stereo DA
The Broadcast Tools
tinyTools 2x6 stereo
distribution amplifier is equipped with a
stereo line level high-Z input, which accepts a balanced
or unbalanced source with six active balanced low-Z
output amplifiers. Individual level controls.
2X6DA List $179.00
Audioarts SDA8400
2x8 Distribution Amplifier
The Audioarts SDA-8400 is a 2x8 rackmount distribution amplifier. Features: LED status lights for all input and output
channels; extremely flat frequency response; separate 3-conductor connectors for each input and output.
SDA8400
List $540.00
Radix DA1600
2x8 or 1x16
Distribution Amplifier
Still at top seller at BSW, the Radix DA1600 is a heavy-duty distribution amp with 8 stereo or 16 mono balanced
outputs. Level control and selectable pads accommodate a wide range of input levels. Features: removable, plug-in
connectors that allow wiring changes to be made quickly and effortlessly with the distribution amp still in the rack;
THD .01% max @ +20 dBm out, SNR 90 dB.
DA1600
List $520.00
Rane DA216S
2x16 Distribution Amplifier
The DA216A is a 2-input, 16-output splitter/distribution amplifier. The DA216A is capable of providing 16 discrete
balanced outputs from one or two balanced mic level or line level inputs. The level of each output is individually
adjusted via one of the sixteen level controls. Each output may be assigned to either or both inputs via accessible
slide switches. The Master A and B Level controls affect the overall level of each input. LEDs indicate an overload at
either the inputs or at the internal gain stages. Input gain switches provide a mic input with +60 or +40 dB of gain,
or a line input with +20 or 0 dB. The DA 216S has Euroblock connectors, and an internal universal power supply.
DA216S
List $519.00
Rolls RA63S
1X8 or 2X4 Distribution Amplifier
The Rolls RA63s is an 8-channel mono/4-channel stereo distribution amplifier. The outputs are designed to drive
high-level balanced lines in a sound distribution system. The screw terminals on the rear panel are for input and
output, and each output may power more than one line.
FeAtureS
:
Input impedance: 100 K ohms balanced ; max input level: +22 dBV
Output impedance: 50 ohms balanced; max output level: +24 dB
rA63
List $188.00
LowestPrice

only $149!
Symetrix 581E
4x16 Distribution Amplifier
The 581E is a high-quality 4-input/16-output distribution amp. Each 1-input, 4-output module operates independently.
Simple rewiring creates 2x8 and 1x16 configurations. Features: removable Phoenix-type connectors for easy installation;
precision circuitry yields THD + noise less than .009%; LED input metering; level control on I/Os; internal power supply.
581e
List $599.00
LowestPrice

only $415!
LowestPrice

only $499!
ESE 1X4
Distribution Amplifier
The ES217 is a 1x4 DA housed
in a free-standing chassis. Barrier
strip or optional XLR connections
(ES217XLR); balanced or
unbalanced I/O.
eS217
List $195.00
$
189
00
eS217XLr List $320.00
$
309
00
LowestPrice

from $189!
LowestPrice

only $459!
ATI Distribution Amplifiers
These rackmount ATI distribution amps come in four models,
depending on the configuration you desire. The DA206 is a dual 1x3
DA and the DA412 is a quad 1x3 DA. Features: outputs are active
balanced and individually adjustable; inputs can be paralleled via internal
jumpers for 1x6, 2x6 or 1x12 operation; balanced XLR input and output
connectors.
The DA208 is a dual 1x4 DA and the DA416 is a quad 1x4 DA. Features:
outputs are active balanced and individually adjustable; inputs can be
paralleled on rear connectors for 1x8, 2x8 or 1x16 operation; barrier
block input and output connectors. The DA208 and DA416 have clipping
indicators. The DA208S version adds signal-present indicators to the DA208.
LowestPrice

from $359!
Aphex 1x4 Distribution Amplifier
The Aphex 120A is a high-performance 1x4 audio
distribution amp. It features one high-impedance input
and four low impedance outputs, all electronically
servo-balanced; half-rack steel chassis; THD < .002% @
+4 dBm; hum and noise better than 90 dB down.
120A List $319.00

LowestPrice

only $279!
LowestPrice

only $169!
ATI Distribution Amplifiers
The ATI DA103 is a 1-in/3-out line level distribution
amp. Features: 1 line level input to 3 servo balanced
outputs @ +22 dBm; master gain control and
independent output level trimmers; individual two-
piece Phoenix-type connectors. The DMA103 is a 1-mic
in/3-line out mic distribution amp. Features: dip switch
selection of phantom power and preamp gain; XLR I/O.
DA103
List $239.00
$
205
00
DMA103
List $279.00
$
239
00
LowestPrice

from $219!
DA206 Dual 1x3 distribution amp XLR I/O
List $529.00
$
459
00
DA412 Quad 1x3 distribution amp XLR I/O
List $749.00
$
639
00
DA208 Dual 1x4 dist. amp barrier I/O, clipping indicators List $409.00
$
359
00
DA208S Dual 1x4 dist. amp barrier I/O, signal indicators
List $459.00
$
399
00
DA416 Quad 1x4 distribution amp barrier I/O
List $599.00
$
519
00
LowestPrice

only $379!
INTERFACE EQUIPMENT DISTRIBUTION AMPLIFIERS order/info: 1·800·426·8434 www.bswusa.com
194
order/info: 1·800·426·8434 www.bswusa.com
Henry Engineering
U.S.D.A
Summing
Distribution Amp
The U.S.D.A. can be used as a
1X4 or 2X4 DA, or to combine a stereo
input to a mono output. Two inputs (one stereo pair) accept
balanced/unbalanced sources; four 600 ohm balanced outs (two stereo pairs); mono/
stereo switches; euroblocks.
uSDA
List $225.00
Accessories:
rMA Rackmount kit for 1-3 units
$
55
00
AEQ
DA-26
2x6 or 1x12
Distribution Amplifier
This compact (1RU) rack-mountable analog audio distribution amplifier feeds one
mono input to 12 mono outputs or two stereo inputs to six stereo outputs. For
ultimate flexibility, it offers independent gain control for each output. All inputs and
outputs are transformer balanced for greater system protection.
FeAtureS:

Max. Input level: + 20 dB
Input impedance: 1.5 kOhms
Adjustable gain: +14 dB for each output
DA-26
List $625.00
Output impedance: < 220 Ohms
Consumption: 8 VA
Universal auto-range PSU:
90-250V / 50-60 Hz
Behringer DI100
Active Direct Box
With the DI100, hum and impedance problems
are things of the past. Features: balanced XLR
and unbalanced 1/4" input/output jacks; switchable
input attenuation allows input levels of up to +50
dBu; Ground Lift isolates grounding circuit for hum
elimination.
DI100
List $49.99
LowestPrice

only $39
99
!
ART Active & Passive Direct Boxes
This Xdirect active direct box connects line
or speaker level signals to a mixer or other
balanced input. The high impedance 1/4"
and XLR inputs are buffered and converted
into an isolated balanced low impedance
signal source. Features: input attenuator
switches allow for a wide range of signal levels;
input link jack allows for tapping off of your signal
chain; ground lift switch helps reduce hum; switchable low pass filter.
Zdirect is a passive direct box.
XDIreCt
List $50.00
$
40
00
ZDIreCt
List $35.00
$
25
00
LowestPrice

from $25!
Whirlwind Active Direct Box
The Whirlwind pcDI interfaces unbalanced stereo
line sources with professional balanced low
impedance equipment. Input your signals with
one 1/8" TRS minijack or two sets of RCA input
and through jacks. Output is via balanced XLRs.
Ground lift switch to help eliminate hum and
a 20 dB pad switch for connecting to hot signals.
PCDI
List $180.00
LowestPrice

only $129!
ART PDB
Passive Direct Box
The new ART Passive Direct Box is a road-rugged
DI for connection of the outputs of electronic
musical instruments (or other audio sources)
to the balanced inputs of mixer consoles and
other balanced inputs. It also lets you connect
a music source to an instrument amplifier while
simultaneously patching it to a mixer.
FeAtureS:
Ground lift switchable
Input attenuation switchable (0dB, -20dB, -40dB)
Instrument Input 50k ohm
Output jack 600 Ohm XLR output jack ; Parallel link jack 50k ohm
PDB
List $45.00
LowestPrice

only $35!
Radial Engineering
Passive Direct Boxes
The PRO-DI is a full-range single channel passive direct
box equipped with custom-made audio transformers
for exceptional signal handling without saturation and
low phase distortion in the bass and mid regions. Its
brilliant clarity and definition make it ideal for acoustic
guitar, bass and keyboards live or in the studio.
The Pro-AV1 is a passive direct box that sports a variety
of stereo inputs that are merged via a resistive mixer to
mono, simplifying signal management. It offers a 1/4"
for instruments, RCA and 1/8" connectors for consumer
electronics, and a +4 dB XLR input for pro systems.
Its custom-wound transformers can withstand
exceptionally hot l