spacing=0 width=100% bgcolor=ccccff> « back to results for ""
Below is a cache of http://usbee.com/dxgs.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.
USBeeDXGettingStartedManual
USBee DX
Test Pod


USB based
Test Equipment
Getting Started
Guide


www.usbee.com
USBee DX Test Pod
Specifications

Dimensions: 2.25" x 1.5" x 0.75"
Shielded High-Speed USB cable: 6 feet
22 gauge test wires with 0.025" square
sockets (total of 24, various colors)
High-Quality miniature test clips allow
connection to narrow pitch components
(total 24 black)
Digital Input Voltage Range: 0V to +5V
Analog Input Range: -10V to +10V
Maximum operating speed in any mode:
24MHz

Computer System Requirements


Windows® 2000, XP or Vista operating
system
Pentium or higher processor
One
USB High-Speed enabled port
(USB
2.0)
64MBytes of RAM
115MBytes of Hard disk space
Internet Access (for software updates and
technical support)

Need Help?


Visit www.usbee.com for Frequently Asked
Questions and Answers
Email your questions to
support@usbee.com


© 2006, CWAV. All rights reserved. Windows is a trademark of
Microsoft. USBee and USBee DX are CWAV trademarks.


Introduction

The USBee DX Test Pod is a powerful embedded
tool in one compact and easy to use pod.
Combined with the Windows® software the USBee
DX Pod has the following features:

16 digital channels
2 analog channels
Oscilloscope / Logic Analyzer
Digital Voltmeter
Signal Generator (optional)
USB, I2C, CAN, SPI, 1-Wire, I2S, PS/2,
SMBus and Async bus decoders
USBee DX Toolbuilder source code
Other digital test tools

The USBee DX System

The USBee DX System consists of the USBee DX
pod connected to your Windows® 2000, XP or
Vista PC through the USB cable, and to your circuit
using the multicolored test leads and clips. Once
connected and installed, the USBee DX Windows
Software can provide each of the various test
functions.

The USBee DX System is also expandable by
simply adding more USBee DX pods for more
channels.



USBee DX Package Contents

USBee DX Universal Serial Bus Pod
USB cable
Set of 24 multicolored test leads and high
performance miniature test clips
Getting Started Guide
USBee DX Windows Software CD

Setting Up Software Installation

1.

Insert the CD into your CD-ROM drive.
2.

From the Start|Run Windows® menu, run
the SETUP.EXE on the CD.
3.

Follow the instructions on the screen to
install the USBee DX software on your hard
drive. This may take several minutes.
4.

Now, plug the USBee DX USB cable into a
free USB 2.0 port on your computer. The
pod will only work on USB 2.0.
5.

You will see a dialog box indicating that it
found new hardware and is installing the
software for it. Follow the on screen
directions to finish the driver install. This
step 5 happens two times
6.

You can now run the new USBee DX
software from the Start|Programs|USBee
DX menu.


USBee DX Users Manual

The USBee DX Users Manual can be found in the
Start|Programs|USBee DX menu.