>. Yahoo! is not affiliated with the authors of this page or responsible for its content.
Netra st D130 Installation and Maintenance Manual
Netra st D130 Installation
and Maintenance Manual
Part No.: 806-1489-10
November 1999, Revision A
Sun Microsystems, Inc.
901 San Antonio Road
Palo Alto, CA 94303-4900 USA
650 960-1300
Fax 650 969-9131
Send comments about this document to:
docfeedback@sun.com
Send comments about this document to:
docfeedback@sun.com Please
Recycle
Copyright 1999 Sun Microsystems, Inc., 901 San Antonio Road, Palo Alto, California 94303-4900 U.S.A. All rights reserved.
This product or document is protected by copyright and distributed under licenses restricting its use, copying, distribution, and decompilation.
No part of this product or document may be reproduced in any form by any means without prior written authorization of Sun and its licensors,
if any. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers .
Parts of the product may be derived from Berkeley BSD systems, licensed from the University of California. UNIX is a registered trademark in
the U.S. and other countries, exclusively licensed through X/Open Company, Ltd. For Netscape Communicator, the following notice applies:
Copyright 1995 Netscape Communications Corporation. All rights reserved.
Sun, Sun Microsystems, the Sun logo, SunStore, AnswerBook2, docs.sun.com, Netra, Solstice DiskSuite, SunSwift, and Solaris are trademarks,
registered trademarks, or service marks of Sun Microsystems, Inc. in the U.S. and other countries. All SPARC trademarks are used under license
and are trademarks or registered trademarks of SPARC International, Inc. in the U.S. and other countries. Products bearing SPARC trademarks
are based upon an architecture developed by Sun Microsystems, Inc.
The OPEN LOOK and Sun Graphical User Interface was developed by Sun Microsystems, Inc. for its users and licensees. Sun acknowledges
the pioneering efforts of Xerox in researching and developing the concept of visual or graphical user interfaces for the computer industry. Sun
holds a non-exclusive license from Xerox to the Xerox Graphical User Interface, which license also covers Suns licensees who implement OPEN
LOOK GUIs and otherwise comply with Suns written license agreements.
RESTRICTED RIGHTS: Use, duplication, or disclosure by the U.S. Government is subject to restrictions of FAR 52.227-14(g)(2)(6/87) and FAR
52.227-19(6/87), or DFAR 252.227-7015(b)(6/95) and DFAR 227.7202-3(a).
DOCUMENTATION IS PROVIDED AS IS AND ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES,
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT,
ARE DISCLAIMED, EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID.
Copyright 1999 Sun Microsystems, Inc., 901 San Antonio Road, Palo Alto, Californie 94303-4900 U.S.A. Tous droits réservés.
Ce produit ou document est protégé par un copyright et distribué avec des licences qui en restreignent lutilisation, la copie, la distribution, et la
décompilation. Aucune partie de ce produit ou document ne peut être reproduite sous aucune forme, par quelque moyen que ce soit, sans
lautorisation préalable et écrite de Sun et de ses bailleurs de licence, sil y en a. Le logiciel détenu par des tiers, et qui comprend la technologie
relative aux polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun.
Des parties de ce produit pourront être dérivées des systèmes Berkeley BSD licenciés par lUniversité de Californie. UNIX est une marque
déposée aux Etats-Unis et dans dautres pays et licenciée exclusivement par X/Open Company, Ltd. La notice suivante est applicable à
Netscape Communicator : Copyright 1995 Netscape Communications Corporation. All rights reserved.
Sun, Sun Microsystems, le logo Sun, SunStore, AnswerBook2, docs.sun.com, Netra, Solstice DiskSuite, SunSwift, et Solaris sont des marques de
fabrique ou des marques déposées, ou marques de service, de Sun Microsystems, Inc. aux Etats-Unis et dans dautres pays. Toutes les marques
SPARC sont utilisées sous licence et sont des marques de fabrique ou des marques déposées de SPARC International, Inc. aux Etats-Unis et
dans dautres pays. Les produits portant les marques SPARC sont basés sur une architecture développée par Sun Microsystems, Inc.
Linterface dutilisation graphique OPEN LOOK et Sun a été développée par Sun Microsystems, Inc. pour ses utilisateurs et licenciés. Sun
reconnaît les efforts de pionniers de Xerox pour la recherche et le développement du concept des interfaces dutilisation visuelle ou graphique
pour lindustrie de linformatique. Sun détient une licence non exclusive de Xerox sur linterface dutilisation graphique Xerox, cette licence
couvrant également les licenciés de Sun qui mettent en place linterface dutilisation graphique OPEN LOOK et qui en outre se conforment aux
licences écrites de Sun.
CETTE PUBLICATION EST FOURNIE "EN LETAT" ET AUCUNE GARANTIE, EXPRESSE OU IMPLICITE, NEST ACCORDEE, Y COMPRIS
DES GARANTIES CONCERNANT LA VALEUR MARCHANDE, LAPTITUDE DE LA PUBLICATION A REPONDRE A UNE UTILISATION
PARTICULIERE, OU LE FAIT QUELLE NE SOIT PAS CONTREFAISANTE DE PRODUIT DE TIERS. CE DENI DE GARANTIE NE
SAPPLIQUERAIT PAS, DANS LA MESURE OU IL SERAIT TENU JURIDIQUEMENT NUL ET NON AVENU. iii
Contents
Preface
xi
Regulatory Compliance Statements
xv
Declaration of Conformity
xix
Safety Agency Compliance Statements
xxi
1.
Netra st D130 Storage Enclosure Overview
1
Components at the Front of the Enclosure
2
Front Panel
2
Front Panel LEDs
3
Components at the Back of the Enclosure
4
Power Switch
5
SCSI ID Switch
5
Back Panel LEDs
6
Internal Components
8
Power Supply
8
Cooling System
9
Disk Drives
11
Foam Fillers
12 iv
Netra st D130 Installation and Maintenance Manual November 1999
Netra st D130 Software Considerations
12
2.
Electrical Requirements and Cable Assembly
13
AC Source Site Requirements
13
DC Source Site Requirements
14
Overcurrent Protection Requirements
15
DC Supply and Ground Conductor Requirements
15
Assembling the DC Input Power Cable
16
Required Connection Materials
16
Isolating the Chassis Ground Connection
23
3.
Installing the Netra st D130 Storage Enclosure
25
Hardware Requirements
25
Preparing for Installation
26
w
To Prepare the Host System
26
w
To Set the SCSI IDs for the Drives
27
Installing the Netra st D130 Storage Enclosure
27
Mounting the Storage Enclosure in a Rack
27
Connecting the SCSI Cables
28
Connecting the Power Cable
30
Powering On and Off
33
w
To Power On the Storage Enclosure
33
w
To Power Off the Storage Enclosure
34
4.
Adding, Removing, and Replacing Disk Drives
35
Adding a Disk Drive
35
w
To Add a Disk Drive
36
Performing the Software Configuration Procedures
37
Removing and Replacing a Disk Drive
39 v
w
To Remove a Disk Drive
39
w
To Replace a Disk Drive
41
A.
System Specifications
43 vi
Netra st D130 Installation and Maintenance Manual November 1999 vii
Figures
FIGURE 1-1
Netra st D130 Storage Enclosure
1
FIGURE 1-2
Removing the Front Panel
2
FIGURE 1-3
Front Panel LEDs
3
FIGURE 1-4
Netra st D130, Rear View
4
FIGURE 1-5
Power Switch
5
FIGURE 1-6
SCSI ID Switch
5
FIGURE 1-7
Back Panel LEDs
6
FIGURE 1-8
Auto Termination Indication LEDs Lit in UltraSCSI or Wide SCSI Daisy-Chain
7
FIGURE 1-9
Auto Termination Indication LEDs Lit in a Narrow SCSI Daisy-Chain
8
FIGURE 1-10
Netra st D130 Rear View (AC Version)
9
FIGURE 1-11
Netra st D130 Rear View (DC Version)
9
FIGURE 1-12
Airflow Requirements (Front and Rear)
10
FIGURE 1-13
Airflow Requirements (Open Rack)
10
FIGURE 1-14
Airflow Requirements (Closed Rack)
11
FIGURE 2-1
DC Connector
16
FIGURE 2-2
Strain Relief Housing
17
FIGURE 2-3
Cage Clamp Operating Lever
17
FIGURE 2-4
Power Connector on the DC Power Supply
17
FIGURE 2-5
Stripping the Insulation From the Wire
18
FIGURE 2-6
Opening the DC Connector Cage Clamp Using the Cage Clamp Operating Lever
19 viii
Netra st D130 Installation and Maintenance Manual November 1999
FIGURE 2-7
Opening the DC Connector Cage Clamp Using a Screwdriver
20
FIGURE 2-8
Assembling the DC Input Power Cable
20
FIGURE 2-9
Inserting the Bottom Portion of the Strain Relief Housing
21
FIGURE 2-10
Routing the Wires Out of the Bottom Portion of the Strain Relief Housing
22
FIGURE 2-11
Securing the Wires to the Strain Relief Housing
22
FIGURE 2-12
Assembling the Strain Relief Housing
23
FIGURE 3-1
Locating the SCSI ID Switch
27
FIGURE 3-2
Netra st D130 Rear View (AC Version)
28
FIGURE 3-3
Daisy-Chaining Netra st D130 Storage Enclosures
29
FIGURE 3-4
Daisy-Chaining a Netra st D130 Storage Enclosure with a Narrow SCSI Device
30
FIGURE 3-5
Netra st D130 Rear View (AC Version)
31
FIGURE 3-6
Connecting the DC Grounding Cable
31
FIGURE 3-7
Connecting the DC Input Power Cable to the DC Connector
32
FIGURE 3-8
Disconnecting the DC Input Power Cable from the DC Connector
33
FIGURE 4-1
Removing the Front Panel
36
FIGURE 4-2
Adding a Disk Drive
37
FIGURE 4-3
Removing and Replacing a Disk Drive
40 ix
Tables
TABLE 1-1
Front Panel LEDs
3
TABLE 1-2
Auto Termination Indication LEDs
6
TABLE 2-1
AC Power Requirements
13
TABLE 2-2
DC Power Requirements
14
TABLE