00% bgcolor=ccccff> « back to results for ""
Below is a cache of http://www.codecorp.com/cmsdocuments/C001569_SupportDoc_SettingsLock.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.
Settings Lock Feature Technical Support Document #C001569

Settings Lock Feature


CR2 firmware versions 2232 and above, includes the following new feature:

The CR2 now has a "Settings Lock" setting where you may lock the reader settings to
prevent unintentional changes.

To enable Settings Lock feature scan the Lock Reader Settings programming code
(M429_01) below:

Lock Reader Settings



To disable Settings Lock feature scan the Settings Unlock programming code
(M428_01)

Unlock Reader Settings



These new codes are also in the CR2 Users Manual and in the CR2 Users Manual
Appendix C.
http://www.codecorp.com/support/usermanuals.htm


*****PLEASE NOTE*******

Prefix and Suffix programming codes, memory transfer and delete commands, "Clear All
CodeXML Rules" and "Suffix Erase/None" commands are not locked by this feature.

If you have any additional questions regarding this feature please contact Code
Corporation Technical Support at
support@codecorp.com
or call (801) 495-2200 x600

9/29/2004

Technical Support Document #C001569