cost effective, heat resistant / electrical molding
material. It exhibits superior dimensional stability, good strength retention at elevated temperature,
and good molded appearance and machinability that account for its widespread use on electrical, and
appliance applications.
Test Method
ASTM (American Society for Testing and Materials)
Features
Cost effective, moulding latitude
Colour
Black
Brown
Material Form
Granular
Type
2-stage
Moulding Method
Compression
Transfer
Injection
Physical Properties
- Bulk Factor
D1895
2.30
- Apparent Density
D1895
0.65 g/cm
2
- Specific Gravity
D792
1.48
- Moulded Shrinkage
D955
0.50 % ~ 1.00 %
- Water Absorption
D570
0.20 %
Mechanical Properties
- Tensile Strength
D638
7,000 psi (48 Mpa)
- Flexural Strength
D790
10,000 psi (69 Mpa)
- Compressive Strength
D695
28,000 psi (190 Mpa)
- Impact, Izod
D256
0.28 ft-lb/in (15 J/m)
- Tensile Modulus
D638
1.3 x 10
6
psi (9,000 Mpa)
- Deflection Temperature @ 264 psi
-
@ 264 psi
D648
191
o
C
Electrical Properties
- Dielectric Strength
D149
325 V/mil
- Volume Resistivity
D257
1 x 10
12
ohm-cm
- CTI Tracking Index
190 V
Flame Resistance
- UL Flammability UL
94V-0 @ 3.05 mm
ASTM Type ASTM
13
Applications
Wiring devices
Fuse holders, etc.,
Note: All specimens prepared by Compression Moulding.
SumiDurez Singapore Pte Ltd
Tel: 65-62651717
Fax: 65-62641916
www.sumidurez.com.sg
Disclaimer: The information presented herein, while not guaranteed, was prepared by
technical personnel and is true and accurate to the best of our knowledge.
No warranty or guarantee, expressed or implied, is made regarding
performance, stability or otherwise.
W e C are