owspan=2 width=10 nowrap> « back to results for ""
Below is a cache of http://www.daybritelighting.com/pdfspecs/ERI4020.pdf. It's a snapshot of the page taken as our search engine crawled the Web.
The web site itself may have changed. You can check the current page or check for previous versions at the Internet Archive. Yahoo! is not affiliated with the authors of this page or responsible for its content.
ERX7015.1
ERI
4020
VNX SERIES
W
et Location Emer
gency Units
Job Name:
Type: ______________________________
Voltage: ____________________________
CODES AND STANDARDS
UL924 listed
Meets NFPA Life Safety Code 101, NEC,
OSHA, Local and State Codes
UL924 Wet Location listed
VOLTAGE INPUT
Universal 120/277VAC field selectable input
CONSTRUCTION
Corrosion resistant NEMA 4X type fiberglass
enclosure in industrial gray finish
Provides protection against dust, dirt, corrosive
atmosphere and water spray (hosedown)
Housing: Corrosion resistant NEMA 4X type
sealed and gasketed enclosure in industrial
gray.
Lighting Heads: Impact resistant, UV stable,
flame rated thermoplastic lamp housing and
swivel assemblies in gray finish to match unit
housing. Heads and swivels are sealed and
gasketed. Lighting heads are fully adjustable
and feature lockable swivels.
LAMPS
High output incandescent lamps maximize
illumination characteristics through a specially
designed reflector and glass lens assembly that
provides glare-free trapezoidal light
distribution.
6 and 12 volt emergency lighting units designed for use in wet or
dirty areas. Units feature corrosion-resistant enclosures, gasketed
construction and sealed lighting heads.
voltage reaches 87.5% of nominal. When
normal utility power is restored, the battery is
automatically disconnected from the load and
a recharging cycle begins that will return the
battery to full capacity within 24 hours.
ELECTRONICS
Charger Type: Fully automatic, temperature
compensating, variable rate float charger
Utility Input: 120/277VAC, 60 Hz.
Power Consumption: 15 watts (maximum)
Temperature Range: 32F to 104F (0C to
40C)
Recharge Duty Cycle: 24 hours
Load Transfer: 6 volt models rated 25 watts or
less and 12 volt models rated 50 watts or less
utilize a solid state transfer circuit for load
connection. All other models utilize
mechanical relays for load transfer and
provide fused DC load connections.
Controls: Momentary test switch and LED
AC-On indicator light
Safety Circuitry:
AC Lockout: Prevents battery discharge prior
to initial unit power-up saving installation
time.
Low Voltage Battery Disconnect: Protects the
battery from being severely damaged by deep
discharge during prolonged power failures.
DC Overload and Short Circuit Protection: On
units with solid state transfer, output
FAMILY
VNX6L - 6V, Lead
Calcium
VNX6N - 6V, Nicad
VNX6P - 6V, Pure Lead
VNX12L - 12V, Lead
Calcium
VNX12N - 12V, Nicad
VNX12P - 12V, Pure
Lead
OPTIONS
VNX6L
3 - 16 watts
5 - 26 watts
7 - 30 watts
9 - 50 watts
11 - 72 watts
VNX6N
3 - 16 watts
5 - 26 watts
7 - 30 watts
9 - 50 watts
VNX6P
3 - 16 watts
5 - 26 watts
7 - 30 watts
9 - 50 watts
11 - 72 watts
VNX12L
12 - 30 watts
14 - 50 watts
16 - 72 watts
18 - 100 watts
20 - 125 watts
22 - 150 watts
VNX12N
12 - 30 watts
14 - 50 watts
VNX12P
12 - 30 watts
14 - 50 watts
16 - 72 watts
18 - 100 watts
20 - 125 watts
22 - 150 watts
OPERATION
TWO LAMP HEADS
LCW - Weatherproof 3-Conductor Line Cord (120V)
TD120 - 15-Minute Re-transfer Time Delay (120V)
TD277 - 15-Minute Re-transfer Time Delay (277V)
220 - 220V, 50Hz Input
TCH120 - Thermostatically Controlled Heater (120VAC)
TCH277 - Thermostatically Controlled Heater (277VAC)
SX - Self-Diagnostic Circuit
PL - Polycarbonate Lamp Lens (For Food Preparation Areas)
SP - Special Paint Finish - Specify Color
6 Volt
BLANK - 7.2w
incandescent
16 - 8w halogen
12 Volt
BLANK - 12w
incandescent
64 - 12w halogen
Lamp Type: Incandescent - wedge base
6 Volt Lamp Rating: 6 volt, 7.2 watt
12 Volt Lamp Rating: 12 volt, 12 watt
Lamp Life: 100 hours (expected average)
BATTERY
Standard Battery: Sealed lead calcium
maintenance free battery designed to provide
many years of dependable service.
Optional Batteries:
Pure Lead extended life
Nickel Cadmium longest life
INSTALLATION
Mounting: Units are designed for installation to
wall surfaces by means of four mounting tabs
provided on the enclosure.
Wiring: Knockouts are provided on both sides
of the enclosure for attachment of surface
wiring or conduit.
OPERATION
Upon failure of the normal utility power, a
solid-state transfer switch automatically
connects the units battery to the emergency
lamp. Emergency illumination will be supplied
for a minimum of 90 minutes. During
emergency operation, the unit battery is
protected from severe discharge damage by an
automatic low voltage disconnect circuit that
discontinues unit operation when battery
Accessories
PG-2
Wire Guard
927-G-03
6V Matching Remote Head-Single (6V, 7.2w)
928-G-03
6V Matching Remote Head-Double (6V, 7.2w)
927-G-59
12V Matching Remote Head-Single (12V, 12w)
928-G-59
12V Matching Remote Head-Double(12V, 12w)
CATALOG NUMBER (Example: VNX6L-7-16) Dimensions - Inches (cm)
Model No.
D
W
H
T
VNX6-3
8-1/2 (21.6)
9 (22.9)
6-1/2 (16.5)
12-1/4 (31.1)
VNX6-5
8-1/2 (21.6)
9 (22.9)
6-1/2 (16.5)
12-1/4 (31.1)
VNX6-7
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX6-9
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX6-11
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX12-12
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX12-14
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX12-16
10 (25.4)
11 (27.9)
8-1/2 (21.6)
14-1/2 (36.8)
VNX12-18
7-3/4 (19.7)
12-1/2 (31.8)
8-1/2 (21.6)
20-1/2 (52.1)
VNX12-20
7-3/4 (19.7)
12-1/2 (31.8)
8-1/2 (21.6)
20-1/2 (52.1)
VNX12-22
7-3/4 (19.7)
12-1/2 (31.8)
12-1/2 (31.8) 20-1/2 (52.1)
© 2007 5-07-DB
DAY-BRITE LIGHTING RESERVES THE RIGHT TO MAKE CHANGES WITHOUT NOTICE.
a Genlyte company
ERI
4020
mcPhilben Lighting
776 South Green Street Tupelo, Mississippi 38804 PH: (662) 842-7212 FAX: (662) 841-5501
www.dcolighting.com
Canadian Division
189 Bullock Drive Markham, Ontario Canada L3P 1W4 PH: (905) 294-9570 FAX: (905) 294-9811
VNX SERIES Wet Location Emergency Units
SPECIFICATIONS
protection is provided by a disconnect circuit that automatically
resets itself when the fault condition is corrected. On units with
mechanical relay transfer, output protection is provided by fused
load connections. See Load Transfer above for details.
Brownout Protection: Automatically switches the unit to
emergency mode when utility voltage is reduced to the point at
which most fluorescent light fixtures would extinguish.
SELF-DIAGNOSTICS
The optional SX self-diagnostics circuit automatically cycles the
emergency lighting unit every 25-30 days. The SX circuit checks
for battery charging and over charging, battery capacity and
reports any system malfunction. By design the SX does not
activate the lighting heads, thus avoiding substantial lamp life
reduction.
WARRANTY
Unit: (excluding lamps) 3-years full coverage against defects in
materials and workmanship from date of shipment
Battery: 3 years full warranty plus an additional 7 years of pro-rata
coverage
DIMENSIONS
T
W
H
D
4-3/4"
(12.1 cm)
Model No.
Volts
Watts For 1-1/2 Hrs.
Watts For 2 Hrs.
Watts For 3 Hrs.
Watts For 4 Hrs.
Standard Lamp
Weight (Lbs.)
VNX6-3
6
16
15
13
9
7.2W incandescent
11
VNX6-5
6
26
20
15
12
7.2W incandescent
13
VNX6-7
6
30
22
17
13
7.2W incandescent
13
VNX6-9
6
50
40
30
24
7.2W incandescent
20
VNX6-11
6
72
66
50
40
7.2W incandescent
20
VNX12-12
12
30
22
17
13
12W incandescent
18
VNX12-14
12
50
40
30
24
12W incandescent
20
VNX12-16
12
72
66
50
40
12W incandescent
20
VNX12-18
12
100
78
50
45
12W incandescent
22
VNX12-20
12
125
94
62
45
12W incandescent
22
VNX12-22
12
150
130
100
80
12W incandescent
22