llspacing=0 width=100%>
Yahoo! is not affiliated with the authors of this page or responsible for its content.
Velocity Transducer Improves Pipette Puller Design Velocity Transducer Improves Pipette Puller Design
Trans-Tek, Inc.
Linear Velocity Transducer Application
800-828-3964
Trans-Tek Series 100 Linear Velocity Transducers are based
on the principle of magnetic induction and provide accurate
velocity measurement in a linear motion. Passing a magnet
through the coil form generates a voltage proportional to the
magnet�s velocity and field strength. This output signal is
used to carefully monitor the speed of moving components in
numerous applications.
A reknkowned laboaratory instrument manufacturer has in-
corporated the Trans-Tek Model 0100-0009 LVT (a slightly
modified version of the standard Model 0100-0000) for ve-
locity feedback in their micropipette puller, a device used for
the fabrication of micropipettes, patch pipettes and microin-
jection needles. Taking advantage of the continuous output
from this sensor resulted in a superior product design by con-
trolling the tip-forming process for each pipette.
In redesigning the puller to manufacture improved micropi-
pettes, the goal facing Sutter engineers was to increase the
rapidity of taper, or, in other words, increase the cone angle at
the end of each pipette. Forces of surface tension around the
capillary tube cause it to attenuate as it is heated and pulled.
While being drawn out over any given length, a slower pull
provides more time for surface tension to act, thereby increas-
ing the rapidity of taper. It was thus determined that increas-
ing the cone angle would require a lowered tip velocity, de-
fined as the pulling velocity during tip formation.
As part of the enhanced design, a preset pulling velocity, re-
ferred to as the criterion velocity, was established for the de-
vice. This value was determined as the ideal point at which
the pull velocity increases just enough to reduce the rapidity
of taper. The pulling cycle is then terminated when this condi-
tion is achieved. The LVT is mounted on the Solenoid Plunger
to monitor the velocity of its fall during the weak pull. The
output voltage of the LVT is then fed into an on-board micro-
processor to control the pulling cycle after the preset criterion
velocity (expressed in the circuitry as voltage) is attained.
When considering various design upgrades, linear position
feedback was also considered for controlling the pulling cycle.
Traditionally, a criterion distance controls the length of time
during which heat is delivered, thus determining the tempera-
ture and viscosity of the glass. Since the pulling velocity is
directly and strongly influenced by the viscosity of the glass,
it was apparent that a velocity sensor would offer distinct ad-
vantages. As a result, Trans-Tek provided the perfect solu-
tion with the Series 100 LVT.
With no excitation voltage required and the DC voltage out-
put varying only with the movement of the magnet, the Linear
Velocity Transducer is a very simple device to use. Compa-
nies such as Sutter Instrument, therefore, are able to integrate
this sensor into their product with little difficulty, reaping the
rewards of better performance and increased reliability.