e
FINISH:
Low Sheen
GLOSS:
5°/60°
VEHICLE TYPE:
Medium Oil/Alkyd
PIGMENT TYPE:
Yellow Iron Oxide, Titanium
Dioxide, Zinc Phosphate, and Silicates
RECOMMENDED COVERAGE RATES:
Approximately 400 sq. ft. per gallon @:
4.0 mils wet film thickness
1.8 mils dry film thickness
DRY TIME (@ 77°F and 50% rel. humidity):
To Touch: 3 hours
To Recoat: 24 hours
MIN/MAX TEMP @ APPLICATION:
40°F min / 95°F max
WEIGHT PER GALLON:
10.5 lbs.
VISCOSITY:
75 KU (±2 KU)
SOLIDS CONTENT:
By Weight: 71% (±1)
By Volume: 45% (±1)
FLASH POINT:
Combustible
RECOMMENDED APPLICATION EQUIPMENT:
Graco or Titan Airless - tip size .013 - .015
-
Spray
Lambswool or synthetic, such as Kodawool or
Pro Weave
-
Roll
Natural bristle, such as Purdy Sprig or Wooster
Friendly
-
Brush
THINNING INSTRUCTIONS:
Thinning is not
normally required. If necessary, use Bennette Paint
Thinner (330010), up to 1/2 pint per gallon.
CLEAN UP:
Clean brushes, rollers, and spray
equipment immediately after use with Bennette Paint
Thinner (330010).
SURFACE PREPARATION:
Surface must be clean,
dry, and free of dirt, grease, oil and grime. Loose rust
and mill scale should be removed by scraping, wire
brushing and sandblasting.
280263
Pros Choice Alkyd Semi-Gloss
25 series
Bright Touch Alkyd Semi-Gloss
24 series
Signature Acrylic Semi-Gloss
Semi-Gloss
38 series
Signature Acrylic Satin Enamel
Satin
280806
Interior Alkyd Eggshell Enamel
4 series
Signature Acrylic Eggshell Enml
Eggshell
1 series
Signature Interior Latex Flat
Flat
I<b>NTERIOR (see NOTE below)
29 series
Quick Drying Enamel
Gloss
17 series
Acrylic 17 Acrylic Enamel
280206
Semi-Gloss Black Enamel
280846
Bronzetone Enamel
Semi-Gloss
280207
Flat Black Enamel
Flat
INTERIOR/EXTERIOR
RECOMMENDED BENNETTE FINISHES:
Other finishes may be acceptable. Contact Bennette Paint
Mfg. Co., Inc. for more information.
NOTE:
Bennette 280233 is recommended as an
intermediate coat on interior surfaces.
FORMULATED WITHOUT LEAD OR MERCURY
102301
PRODUCT DATA
PAINT MFG. CO., INC.
YELLOW
RUST INHIBITING
METAL PRIMER
280237
All technical advice, recommendations and services are rendered by the Seller gratis. They are based on technical data that the
Seller believes to be reliable, and are intended for use by persons having skill and know-how at their own discretion and risk.
Seller assumes no responsibility for results obtained or damages incurred from their use by Buyer in whole or in part. Such
recommendations, technical advice or services are not to be taken as a license to operate under or intended to suggest
infringement of any existing patent.
EMPLOYEE
OWNED
COMPANY