cing=0 width=100%>
Yahoo! is not affiliated with the authors of this page or responsible for its content.
Salsa.Brake.Booster.Instr 1. Slide brake arms onto appropriate brake mounting boss.
*Note: Brake mounting bosses must be between 73mm and
100mm apart (center to center) for the Arc de Trioomph to fit.
2. Slide mounting bolt with washer through each hole on the Arc de
Trioomph with the heads of the bolts facing the same direction as
the Salsa logo. Slide a shouldered spacer onto each bolt with the
small end facing away from the Arc de Trioomph. An additional
spacer inserted between the Arc de Trioomph and the shouldered
spacer may be necessary for the Arc de Trioomph not to interfere
with the brake arms movement. For best performance, use as few
spacers as possible to position the Arc de Trioomph as close as
possible to the brakes.
*Note: Two sets of mounting bolts are supplied with the Arc de
Trioomph. Use the longer bolts unless they bottom out before
tightening down on the Arc de Trioomph. This will ensure proper
thread engagement and prevent damage to the brake mounting
bosses. Achieving the proper combination of spacers and bolts may
take a few tries. Taking time now to get it right will pay off later
(i.e. when you are riding your bike).
3. Loosely install the assembly onto the bike by threading the mounting
bolts into the brake mounting bosses. Do not tighten the bolts yet.
4. Center the Arc de Trioomph over the brake mounting bosses and
tighten each bolt to a torque of 45-60 in-lbs.
5. Check to make sure the Arc de Trioomph does not interfere with
the movement of the brake arms.
6. Check assembly for tightness before each ride.
WARNING
Do not try to install this item if you do not understand the instructions or if you do not have the proper tools. Please have this item installed
by the professional, experienced mechanic at your local bike shop. Remember, these are your brakes!
Salsa Arc de Trioomph Brake Booster
I N S T R U C T I O N S
Salsa Cycles Limited Lifetime Warranty
This Salsa
®
product is warranted against defects in materials and workmanship for the lifetime of the product subject to the limitations detailed below. This
limited warranty is expressly limited to the repair or replacement of the original product, at the option of Salsa Cycles, and is the sole remedy of the warranty.
This limited warranty applies only to the original purchaser of the Salsa
®
product and is not transferable.
In no event shall Salsa Cycles be liable for any loss, inconvenience or damage, whether direct, incidental or consequential or otherwise resulting from breach
of any express or implied warranty or condition, of merchantability, fitness for a particular purpose, or otherwise with respect to this product except as set
forth herein.
This warranty does not cover the following:
damage due to improper assembly or follow-up maintenance or lack of skill, competence or experience of the user or assembler
products that have been modified, neglected, used in competition or for commercial purposes, misused or abused, involved in accidents or anything
other than normal use
damage or deterioration to the surface finish, aesthetics or appearance of the product
normal wear and tear
labor required to remove and/or refit and re-adjust the product within the bicycle assembly
This warranty gives the consumer specific legal rights, and those rights and other rights may vary from state to state.
6400 West 105th Street Bloomington, MN 55438
877-MOTO-ACE www.salsacycles.com
1. Mounting Bolt
2. Washer
3. Arc de Trioomph
4. Spacer
5. Shouldered Spacer
6. Brake Arm
7. Brake Mounting Boss
(part of frame)
Salsa.Brake.Booster.Instr 5/25/04 11:18 AM Page 1