EFULLY BEFORE
attempting operation.
STAND AID INFORMATION
OPERATING INSTRUCTIONS
REPLACEMENT PARTS GENERAL INFORMATION

After unpacking your Stand Aid, place any parts that are not at-
tached to the Stand Aid on the floor, using the parts list to get familiar
with the unit and parts. On the standard Stand Aid there should be no
tools needed to adjust the unit for your standing pleasure. Check
your packing list for the options that came with your unit.


Parts included in the standard unit, 1 Safety Belt, 2 Heel straps,
1 Toe Strap, 1 4 Safety Gate Pad, and 1 2 Safety Gate Pad.


All Stand Aid models should be used only on level, smooth
surfaces. Please exercise caution and good judgement when
operating your unit.
INTRODUCTION
Thank you and congratulations on your purchase of the STAND AID
Model 1502. We are certain the benefits you receive from standing with
our Stand Aid will enhance your health and outlook on life.
Quick Overview of Standing Instructions
1. Adjust frame to desired height, making sure all knobs are tight.

2. Make sure table is adjusted high enough.

3. Open Safety Gate, place your feet onto the floor of the Stand Aid in the Heel
Straps and Toe Straps.

4. After you are in the up position, close the Safety Gate into the locked position.

5.
Stand Aid recommends that you have someone there when you are

standing
for the first time.
TABLE OF CONTENTS
Cover ......................................................................................Page #1
Introduction and General information......................................Page #2
Table of Contents....................................................................Page #3
Limited Warranty information .................................................Page #4
Getting to know your Stand Aid ...............................................Page #5
Safety Precautions..................................................................Page #6
Preventive Maintenance & Repair...........................................Page #7
Parts Breakdown and Part List..............................................Pages #8
Part List and Additional Options ...........................................Pages #9
Safety Gate and Back Support Options ......................... Pages #10-11
Battery Installation ................................................................Page #12
Battery Charging Information ................................................Page #13
Operating Instructions....................................................Pages #14,15
Drive Wheel Clutch Pin/Operating Drive Control...................Page #16
Drive Control Information ......................................................Page #17
Drive Control Care ................................................................Page #18
Stand Aid Additional Options .................................................Page #19
Stand Aid Part Ordering Policies ...........................................Page #20

WHEN CALLING FOR SERVICE PLEASE HAVE THE SERIAL NUMBER OF
YOUR UNIT READY FOR THE STAND AID REPRESENTATIVE. THIS WILL
HELP IN THE SERVICING OF YOUR STAND AID PRODUCT.
STAND AID MODEL 1502
STANDARD FRAME
WITH DRIVE LIMITED WARRANTY

Each Stand Aid of Iowa, Inc. product has been care-
fully inspected and tested before shipment. Accord-
ingly, we warrant each STAND AID which is sold
against defects in workmanship and material under
normal use for life, excluding the motor, drive train and
electrical components which are warranted for one
year and the batteries which are warranted for 90 days.
This warranty shall not extend to and we shall have no
responsibility with respect to products which have been
abused, misused, altered or as to which repair has
been made or attempted by others.

This warranty is made in lieu of all other warranties
with respect to the product covered hereby and there
are no other warranties, whether expressed or implied,
of merchantability or otherwise, except the warranty ex-
pressly stated herein. The remedy set forth herein
shall be the sole exclusive remedy of any purchaser
with respect to any defective product. Under no cir-
cumstances shall STAND AID of IOWA be liable for any
injury, loss, damage or expense suffered or incurred
with respect to any misuse of STAND AID of IOWAS
products.

If you have any questions or need further informa-
tion, please feel free to call our offices at: 1-800-831-
8580.

Page 4
ATTENTION: IMPORTANT
!


We ask that you take time to acquaint yourself with your Stand Aid, its
adjustments and controls. We highly recommend that someone assist you as you
familiarize yourself with the unit.


Again, we remind you to use your Stand Aid only on level, smooth surfaces.

INSTRUCTIONS FOR STAND AID MODEL 1502


Remove the table from the lower half of the Stand Aid unit and place it
in the table mounting bracket. Remove the safety gate pads that are
packed behind the table.


Table Mounting
Bracket
Small Shroud
Large Shroud
Front Metal
Shroud
Rear Caster

Wheels

Side Metal
Shroud
Upper Side Rail
Page 5
Knee Pad
Adjustment Knobs
Horizontal Table
Adjustment
Safety Gate not shown
Refer to Pages 10 & 11. SAFETY PRECAUTIONS
READ THIS BEFORE OPERATING YOUR UNIT!!!!
1. If at all possible have an attendant help you with the first several
stands, to help with adjustments of the unit for your comfort and safety.

2. Always use on a level and smooth surface.

3. Never operate the unit if it appears damaged.

4. Never operate the unit if it is not operating correctly, consult our
service department.

5. Keep all body parts away from moving parts on the unit at all times.

6. Always keep younger children away from this unit. Never allow
younger children to operate this unit.

7. Always try to keep the unit in proper working condition.

8. Replace Battery if it is damaged or leaking, dispose of damaged
battery.

9. When Stand Aid is not in use always unplug the power source from
the battery (1501) or batteries (1502 & 1503).

Page 6 PREVENTIVE MAINTENANCE AND REPAIR
Keep all electrical connections clean and dry.


Do not allow joystick or control module to become exposed to

moisture.


For the following lubrications, we recommend that you carefully tip

the Stand Aid forward, laying it face down on the floor. The

power drive sprocket, and chains are located under the floor

base.


Lubricate power drive sprockets with one shot of grease every six

months. Clean and lightly lubricate drive chains with lightweight

oil. (see picture below)

If the drive unit operates slowly, charge the batteries for 18-24
hours. If the unit still operates slowly, you may need to change
bat teries. Replacement batteries may be ordered by calling Stand

Aid of Iowa at 1-800-831-8580.



For any repairs, maintenance or trouble shooting, please feel free to
call during regular business hours from 7:00 A.M. to 5:00 P.M. CST.


Lubricate with grease
Lightly lubricate chain
with household oil
Page 7 PAR
TS
1
2
3
4
5
6
7
8
9
10
11
30
27
28
31
12
32
26
13
18
15
29
33
14
17
34
25
20
23
34
36
24
16
22
35
21
Page 8
SAFETY GATE SEE
PAGES 10 & 11
19 1. 85002002 1/1 Lower Side Rt/Lt.
2. 85002003 1
Lower Front
3. 85002000 1/1 Upper Sides Rt./Lt.
4. 85002007 1
Floor Pan
5. 85002019 1/1 Table Hinge Rt./Lt.
6. 85002004 1
Table Frame
7. 85002001 1
Knee Pad Bracket
8. 85002029 2
Frame Tube Insert
9. 85002008 2
Knee Pad Slide
10. 85002006 2
Chain Cover
11. 85002005 2
Side Shroud
12. 85002021 1/1 Power Drive Fork Rt./Lt.
13. 85002016 1
Front Shroud
14. 85002022 1
Battery Pan
15. 25003030 2
Battery
16. 85002009 1
Table Slide Bracket
17. 26003021 1
Small Shroud

18. 26003022 1
Large Bottom Shroud
19. 26003002 1
Knee Pad
20. 26003003 1
Table Pad
21. 26003023 2
Hip Pad
22. 85002013 2
Table Clip
STAND AID MODEL 1502 PARTS LIST
REF. # PART # QTY.
DESCRIPTION
Page 9
Please order parts by
PART NUMBER and DESCRIPTION.
23. 25003024 1
Controller
24. 85002025 1
Joystick Mount
25. 85002027 1
Joystick Slide
26. 25003025 1/1 Motor Rt./Lt.
27. 25003026 2
Power Drive Wheel
28. 85002030 2
Power Wheel Spacer
29. 85002023 2
Axle
30. 85002014 2
Hub with Sprocket
31. 25003031 2
Motor Sprocket
32. 25003027 2
Caster Wheel
33. 85002012 1
Battery Tie Down Strap
34. 25003000 14 Adjustment Knob
35. 85002018 1
Chest Pad Mount
36. 82002017 1
Table Plexi Glass

37. 26003007 2
Heel Strap
(not shown)

38. 26003008 1
Toe Strap
(not shown)

39. 26003024 1
Sling w/ rings
(not shown)

40. 25003032 2
Drive Chain
(not shown)


REF. # PART # QTY.
DESCRIPTION
STAND AID ADDITIONAL OPTIONS


Safety gate back support for those requiring more back support. (see page 10.)


To accommodate larger wheelchairs, we offer caster brackets.


Joystick bracket extension allowing the joystick to be placed in the center of the ta-
ble.


T