d Grandview, MO 64030 (816) 765-5011
Taylor Cable Products, Inc.
301 Highgrove Road
Grandview, MO 64030
(816) 765-5011


www.taylorvertex.com
/
info@taylorvertex.com



4-POLE MASTER DISCONNECT SWITCH #1033

MOUNTING
1.
Determine the mounting location for the switch following your sanctioning
guidelines.
2.
Drill a 25/32 hole through the panel you are mounting through to accept the
switch-mounting stem.
3.
Remove the switch handle loosing the screw in the center. Remove the first nut
and lock washer. Pass the switch through the hole in the panel and secure in
place using the lockwasher and nut. Re-attach the switch handle.
4.
Apply the ON/OFF Label.

WIRING
1.
Disconnect the positive and negative battery terminal. Make sure the switch in the
off position.
2.
Connect a battery cable from the starter or starter solenoid to one of the 1/2
switch terminals. The battery cable should be a minimum of 2-gauge wire.
3.
Connect a jumper wire from the alternator output terminal to one of the 3/16
terminals. Use a minimum of 10-gauge wire for this connector (maximum current
20 amps).
4.
Connect a jumper wire to remaining 1/2 terminal to the remaining 3/16 terminal.
5.
Connect the positive terminal on the battery to the 1/2 stud on the switch that has
the jumper wire mounted to it. Use a minimum of 2-gauge wire for the connection.
6.
Reconnect the positive and negative battery terminals; making certain the
negative side of the battery is fastened to a clean ground, preferably the engine
block.

7.
To check the wiring: turn switch on, start the vehicle, and turn switch off. The
vehicle should stop running. If not, re-check your wiring to the diagram below.




Form #IS023
Rev 6/04


Taylor Cable Products, Inc.
301 Highgrove Road
Grandview, MO 64030
(816) 765-5011
www.taylorvertex.com
/
info@taylorvertex.com



4-POLE MASTER DISCONNECT SWITCH # 1033

MOUNTING
1.
Determine the mounting location for the switch following your sanctioning
guidelines.
2.
Drill a 25/32 hole through the panel you are mounting through to accept the
switch-mounting stem.
3.
Remove the switch handle loosing the screw in the center. Remove the first nut
and lock washer. Pass the switch through the hole in the panel and secure in
place using the lockwasher and nut. Re-attach the switch handle.
4.
Apply the ON/OFF Label.

WIRING
1.
Disconnect the positive and negative battery terminal. Make sure the switch in the
off position.
2.
Connect a battery cable from the starter or starter solenoid to one of the 1/2
switch terminals. The battery cable should be a minimum of 2-gauge wire.
3.
Connect a jumper wire from the alternator output terminal to one of the 3/16
terminals. Use a minimum of 10-gauge wire for this connector (maximum current
20 amps).
4.
Connect a jumper wire to remaining 1/2 terminal to the remaining 3/16 terminal.
5.
Connect the positive terminal on the battery to the 1/2 stud on the switch that has
the jumper wire mounted to it. Use a minimum of 2-gauge wire for the connection.
6.
Reconnect the positive and negative battery terminals; making certain the
negative side of the battery is fastened to a clean ground, preferably the engine
block.

7.
To check the wiring: turn switch on, start the vehicle, and turn switch off. The
vehicle should stop running. If not, re-check your wiring to the diagram below.




Form #IS023
Rev 6/04