lspacing=0 width=100%>Yahoo! is not affiliated with the authors of this page or responsible for its content.

REMOVAL �

�

Instrument Panel (Part 1)

�

�

Instrument Panel (Part 2)

�

�

Instrument Panel (Part 3)

�

�

Instrument Panel (Part 4)

�

�

�

HINT: Screw shapes and sizes are indicated in the table.The
codes ("A" - "M") correspond to those indicated.

REMOVE STEERING WHEEL PAD AND STEERING WHEEL
REMOVE DOOR SCUFF PLATE
REMOVE COWL SIDE TRIM
REMOVE NO.1 SWITCH HOLE BASE




�
�



REMOVE LOWER INSTRUMENT PANEL FINISH PANEL

Remove the 3 screws and disconnect the connector.
Using a screwdriver, remove the lower instrument
panel finish panel.




�

HINT: Tape the screwdriver tip before
use.

REMOVE LOWER PANEL INSERT Remove the 4 bolts and
lower panel insert.
REMOVE COLUMN COVERS
REMOVE SPIRAL CABLE
REMOVE WIPER AND WASHER SWITCH AND LIGHT CONTROL
SWITCH AND HEADLIGHT DIMMER SWITCH
REMOVE CLUSTER FINISH PANEL Using a screwdriver,
remove the cluster finish panel.




�

HINT: Tape the screwdriver tip before
use.

�
�



REMOVE COMBINATION METER

Push out the connector by loosening the bolt.




�

NOTE: Operation is completed when
the bolt failed to catch.

Check that the red-colored indicator is pulled back
behind.
Remove the 4 screws.




�
�



REMOVE INSTRUMENT CLUSTER FINISH PANEL

Remove the 4 bolts.
Using a screwdriver, remove the instrument cluster
finish panel.




�

HINT: Tape the screwdriver tip before
use.

w/o Radio: Remove the 4 bolts and stereo opening
cover.
w/ Radio: Remove the 4 bolts and radio then disconnect
the connectors.



REMOVE HEATER CONTROL ASSEMBLY




�
�



REMOVE INSTRUMENT PANEL CLUSTER FINISH CENTER PANEL

Remove the 2 screws.
Using a screwdriver, remove the instrument panel
cluster finish center panel then disconnect the connector.




�

HINT:

After
removing the screws, if you remove the clip shown by an arrow mark with
a resin spatula, the panel can be removed smoothly.
Tape
the screwdriver tip before use.




�



REMOVE UPPER CONSOLE PANEL

M/T only: Remove the shift lever knob.
Using a screwdriver, remove the upper console panel.




�

HINT: Tape the screwdriver tip before
use.

�



REMOVE REAR CONSOLE BOX Remove the 2 bolts, 2 screws
and rear console box, then disconnect the connector.




�
�



REMOVE FRONT CONSOLE BOX

Remove the 6 screws and front console box.
Using a screwdriver, remove the front console box
to indicated direction.




�

HINT: Tape the screwdriver tip before
use.

REMOVE NO.1 AND NO.2 INSTRUMENT PANEL UNDER COVERS
REMOVE GLOVE COMPARTMENT BOX
REMOVE INSTRUMENT SIDE PANEL
REMOVE STEERING COLUMN




�



REMOVE FRONT PILLAR GARNISHES

Using a screwdriver, remove the front pillar garnish.




�